- 14 -
How to copy, paste and cut a program
After selecting a program, it is possible to copy it and paste it to another memory position.
Touch the program position to be copied for 2
seconds until the
COPY PASTE CUT
bar is
indicated. Then press the intended option. For
example press “COPY”. After this, touch the
memory position where the program shall be
copied to.
Then touch the same position again and remain
for 2 seconds until the
COPY PASTE CUT
bar appears. Now touch
“PASTE” and the original program is copied into
the new memory position.
Use “CUT” for erasing a memory position
(=program/protocol).
Use to leave the procedure without any further action.
IMPORTANT: please be aware that the 100 memory areas of “123” and “DUO” are different. It is not
possible to copy from one area to another.
How to input a frequency value
The menus “123” or “DUO” must be used to open the program where an additional, or a changed,
frequency value should be entered. A frequency value can only be input if the button “PROTECT” in
the SETUP menu is inactive. If PROTECT is active, the frequencies are indicated but it is not possible
to modify the value of an entry.
The yellow arrows in the menus “123“ and “DUO” are used to select the position (1 to
50) for the new frequency value to be inserted in the opened program.
Next, the present frequency value has to be touched
A numerical key block opens and the new value can be entered.
A touch on the ENTER-key saves the input
The properties of frequencies
Runtime
The factory setting of the runtime per frequency is 3:00 minutes. It can be changed after a touch on
the above icon and the input of the minutes and seconds to be applied.
A touch on the ENTER-key “E” saves the input.
