Taylor C001, Руководство оператора

Страница: 24 / 44

6-2
OPERATING PROCEDURES
Models C001 and C002
Operating Procedures
6
Figure 6-3
3. Assemble the dasher. Take one of the scraper
blades and slip it under the hook at the front of the
dasher. Wrap the blade around the dasher, following
the helix and pushing the blade down onto the helix
as you wrap. At the back end of the dasher, slip the
blade under the hook.
Repeat this step for the other
scraper blades.
Figure 6-4
4. Install the dasher. Slide the dasher into the freezing
cylinder and over the end of the driveshaft. The
dasher should fit snugly, but not so tightly that the
dasher cannot be turned slightly to engage the
driveshaft. If the dasher slides in too easily with little
or no resistance, there will not be enough force
against the dasher to hold the blades in place. If this
is the case, contact your authorized Taylor service
technician.
Figure 6-5
Note: A dasher installation/removal tool is available
to assist in the installation and removal of the dasher.
To install the dasher, insert the short bars of the tool
into the slots in the end of the dasher. Using the long
bar of the tool, push the dasher until it is properly
installed in the freezing cylinder.
Figure 6-6
Install the front bearing into the front of the dasher
assembly.
Figure 6-7
11381
11197