OPERATING PROCEDURES
6-3
Models 8752, 8756, and 8757
Operating Procedures
6
Figure 6-7
8. Slide the beater assembly the rest of the way into the
freezing cylinder.
Make sure the beater assembly is in position over the
driveshaft. Turn the beater slightly to make sure that
the beater is properly seated. When in position, the
beater
will not
protrude beyond the front of the
freezing cylinder.
9.
for the other side of
the machine on Models 8756 and 8757.
10. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: door
bearing, door gasket, draw valve, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
11. Place the large rubber gasket(s) in the groove(s) on
the back side of the freezer door.
Slide the white plastic front bearing(s) over the baffle
rod(s), making sure that the flanged end of the
bearing is resting against the freezer door.
Do Not
lubricate the gasket(s) or front bearing(s).
Figure 6-8
Note:
There are two gaskets and two front bearings
for the Models 8756 and 8757 door, one for each
freezing cylinder.
12. Slide the O-rings into the grooves on the prime
plug(s). Apply an even coat of lubricant to the O-rings
and shaft(s).
Figure 6-9
Note:
There are two prime plugs for models 8756
and 8757 door, one for each freezing cylinder.
13. Insert the prime plug(s) into the hole(s) at the top of
the freezer door and push down.
Figure 6-10
Apply the appropriate
Taylor approved food safe lubricant.
Содержание 8757
