Taylor 8757, Оригинальная инструкция по эксплуатации

Страница: 40 / 58

6-12
OPERATING PROCEDURES
Models 8752, 8756, and 8757
Operating Procedures
6
14. Repeat steps 1 through 13 for the second freezing
cylinder on Models 8756 and 8757.
15. Prepare a sink with an approved sanitizing solution
(examples: Stera-Sheen
®
or Kay-5
®
). Use warm
water and follow the manufacturer’s specifications.
16. Take the following parts to the sink and sanitize: mix
tank(s), mix tank cover(s), mix probe(s), mix storage
cover(s) and funnel(s).
Priming
1. Sanitize the mix tank, the mix tank cover, the mix
probe, the mix storage cover, and the funnel. Place
the mix tank and the cover in the mix cabinet.
2. Insert the prongs of the mix probe inside the mix
tank. Connect the mix probe in the socket receptacle.
Figure 6-46
3. Place the free end of the suction line down in the mix
tank.
Figure 6-47
Important! Use only fresh mix when priming the
machine.
4. Install the funnel. Fill the mix tank with fresh mix.
Figure 6-48
5. Remove the funnel and install the mix storage cover.
Close the mix cabinet door.
6. Place an empty pail beneath the door spout and
open the draw valve. With the prime plug still in the
up position, press the PUMP button. This will allow
the mix to be pumped through the freezing cylinder
and force out any remaining sanitizer. When

full-strength mix is flowing from the door spout, close
the draw valve.
7. When a steady stream of mix is flowing from the
prime plug hole in the bottom of the freezer door,
press the PUMP button to stop operation.
Figure 6-49
15064
15065
Figure 57
15066