Taylor-Dunn MB-238-00, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 86 / 194

Maintenance, Service, and Repair
Transmission Page 12
DISASSEMBLING THE 3RD MEMBER
1. Make sure the key-switch is in the “OFF” position, then remove the
key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
6. Raise the rear of the vehicle and support with jack stands.
7. Remove the complete drive from the vehicle.
NOTE: Refer to
Removing and Installing the Drive Assembly
for
information on removing the drive from the vehicle.
8. Place a drain pan under the gear case that is capable of holding four quarts of oil and drain
the oil from the front gear case and 3rd member.
9. Place the 3rd member on an appropriate stand.
10. Remove the axle shafts and tubes as an assembly from
the 3rd member by removing the six axle tube flange
bolts on each axle tube.
11. Remove the primary reduction gear case. Refer to
Disassembly and reassembly of the Primary
Reduction Gear Case
for information on removing
the gear case.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
12. Remove the 12 side plate bolts, then remove the side
plate.