Taxa Outdoors Cricket 2019, Руководство пользователя

Страница: 27 / 65

C RIC K E T
®
www.taxaoutdoors.com
1830 west 15th street houston, tx 77008 usa (rev.11292018) 27
(1) fill the fresh water tank as instructed;
(2) turn on the water pump switch;
(3) Turn on the sink faucets both hot and cold, allowing time for the water heater to fill … Note: be sure that your faucet i s set to engage hot
water flow. If not engaged for hot water flow, which fills the hot water tank with water and protects the heating element. If you own an
“electric” cricket your water heater ’ s heating element can burn and be destroyed. Also, remember that it takes some amount of time for
the water to rise approximately Hot Water heater is turned. This depends on inlet temperature AND the settings on your electric or propane
hot water heater.
(4) turn off each sink faucet as the water flow becomes steady and free of air (stops sputtering, and a solid stream of water flows from the
faucet ;
(5) allow the water pump time to stop running … the water pump should stop running shortly after the sink faucets are turned off; and
(6) the system is now ready for use.
water heater …
if your Cricket is equipped with the 120V water heater it is located in the bottom area of the kitchen cabinet. Turn on the water pump to fill
the water heater completely before turning it on (
switch is located on the HW heater itself ). If camping without shore power (120v) this heater
will not work. The time required for Hot Water will vary depending on the starting temperature of the water. Thermostat settings for the
water heater are located at the dial switch on the heater itself.
HW Heater HW heater with storage removed – shows GFCI outlet and connections.
if your Cricket is equipped with the TRUMA system
– combined propane furnace and HW heater please refer to the TRUMA manual for
instructions and maintenance procedures. The controls for the TRUMA are electric and are operated from the kitchen switch panel.
TRUMA location cover plate removed ON / OFF switch on top right of unit
switch location (located on flat portion of
right side top). The switch is ON, when the
front (closest to inside of trailer) of the
switch is pushed down.