Taurus T9.5, Руководство по сборке и эксплуатации

Страница: 15 / 60

T9.5
15
2.4 Care and maintenance
The most important maintenance measure is taking care of the running belt. It
includes the adjustment, tensioning and lubrication of the running belt. Damage
caused due to a lack of care or negligence will not be covered by the warranty. Thus,
check for maintenance in regular intervals. Be extremely careful when adjusting and
tensioning the belt, because a strong over or under tension may cause damages. The
running belt is set properly in the factory before delivery. However, the running belt
may get out of place during transport.
Aligning the running mat
During training, the running belt should run as centered and straight as possible. The
alignment of the running belt may change depending on the stress and load. Another
reason can be the positioning of the equipment on an uneven surface.
+ While adjusting the belt, let the equipment run with a speed of approximately
5km/h. Nobody may be on the equipment during this process.
+ If the running belt is offset to the left, turn the left setting screw on the rear end
of the equipment at most 1/4 rotation clockwise and the right setting screw at most
1/4 rotation counterclockwise (fig. C).
+ If the running belt is offset to the right, turn the right setting screw on the rear
end of the equipment at most 1/4 rotation clockwise and the left setting screw at
most 1/4 rotation counterclockwise (fig. D).
+ Then watch how the belt runs for approximately 30 seconds, because the change
will not be visible immediately.
+ Repeat the process until the running belt runs straight again. If the running belt
cannot be adjusted, please contact your contract partner.