Taurus 973965000, Руководство пользователя

Страница: 8 / 48

-Prepare the food to be fried and place it in the
basket, making sure that it does not rise above
¾ of its capacity. Allow the food to drain before
placing it in the basket.
-Frozen food must be allowed for thaw before-
hand. The placing of frozen food or food with
high water content in the basket may cause the
oil to suddenly spit after a few seconds.
-Wait until the pilot light (D) has gone out which
will indicate that the appliance has reached an
adequate temperature.
-Slowly place the basket in the bowl to avoid
overflowing and splashing.
-When the food has been fried sufficiently, lift the
basket and position it in the support in order to
allow the excess oil to drain from the food.
-Empty the basket.
-Change the oil approximately every 15 or 20
frying operations, or every 5 – 6 months if not
used frequently.
-In order to minimize the generation of acryla-
mide during the frying process, avoid reaching
dark brown colours on the fried food, remove
any burnt leftovers from the oil container, food
rich in starch (such as potatoes or corns) should
be fried at temperatures lower than 170ºC.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
-Select the minimum position (MIN) using the
thermostat control.
-Unplug the appliance from the mains.
-Put the cable back in the cable housing.
-Fit the basket into the tank.
-The basket handle may be left attached or you
can whisk towards the interior of the basket by
pressing sideways on the rods and pivoting.
-Close the lid.
CORD HOUSING
-This appliance has a cable compartment situa-
ted on its posterior.
CARRY HANDLE/S:
-The device has a handle on the upper part so it
can be transported easily and comfortably.
PRACTICAL RECOMMENDATIONS:
-Fry a few pieces of bread to remove the smell
of used oil.
-For food with a high water content, it is better
and quicker to fry in two lots with less food than
in just one. This will reduce the risk of splashes
and spillage.
-This will reduce the risk of splashes and spilla-
ge. This system consists of first frying the food
until it is reasonably well done and then frying
again using very hot oil to brown the food.
-Olive oil with a minimum acidity level is recom-
mendable for frying.
-Do not mix different oils.
-Wash potatoes before frying to stop them from
sticking.
SAFETY THERMAL PROTECTOR:
-In the event of overheating, the thermal safety
mechanism will be activated and the applian-
ce will stop operating. When this occurs the
appliance should be disconnected from the
mains and left to cool. Then press the rearming
button, situated at the back of the electrical
circuit, with the tip of a pen or similar in order to
reactivate the appliance (Fig.1)
CLEANING:
-Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
-Dismantle the appliance as follows:
-Take off the lid
-Remove the basket and take out the electri-
cal equipment
-Remove the tank
-Carefully pour the used oil from the bowl
into a container (not the sink), according to
the regulations in force for the treatment and
disposal of waste.
--Except for the power unit and the mains
connection, all the parts can be cleaned with de-
tergent and water or in washing up liquid. Rinse
thoroughly to remove all traces of detergent
-Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQUID.
-Clean the equipment using a damp cloth with a
few drops of washing-up liquid and then dry.
-Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
-Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
-If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance’s useful life
and could become unsafe to use.