19
K892M
SOFTWARE Version 3.10 onwards - Table 2
DIP 4 DIP 8
Set mode
TM1
TM2
TM3
OFF
OFF
No deceleration
No ENCODER
Optional
LS (limit switches)
Automatic
closure
time
Work time
Not used
OFF
ON
No deceleration
ENCODER necessary
LS (limit switches)
required
Automatic
closure
time
Work time
Encoder
sensitivity
ON
OFF
Deceleration with settable
time. Work time and decelera
-
tion established by the SETUP
procedure
No ENCODER
Optional
LS (limit switches)
Automatic
closure
time
Not used
Not used
ON
ON
Deceleration with settable
time. Work time and decelera
-
tion established by the SETUP
procedure
ENCODER necessary
LS (limit switches)
required
Automatic
closure
time
Not used
Encoder
sensitivity
433.92 MHz BUILT-IN RADIO RECEIVER
The radio receiver can learn up to a maximum of 30 rolling codes (BUG2R, BUG4R) which can be set
on the two channels as required.
The first channel directly commands the control board for opening the automatic device; the second
channel commands a relay for a N.O. no-voltage output contact (terminals 9 and 10, max. 24 Vac, 1
A).
LEARNING SYSTEM FOR RADIO CONTROL DEVICES
P1 = OPEN/CLOSE
P2 = 2nd channel
1_ press button P1 briefly to associate a radio control device with the OPEN/CLOSE function;
2_ LED DL7 turns off to indicate that the code learning mode has been activated (if no code is en
-
tered within 10 seconds, the board exits the programming mode);
3_ press the button of the relative radio control device;
4_ LED DL7 turns on again to indicate that the code has been memorised
and then off again imme-
diately waiting for other radio control devices (if this is not the case, try to re-transmit or wait 10
seconds and restart from point 1);
5_
to memorise codes to other radio control devices, press the key to be stored on other devices
within 2-3 sec. After this time (DL7 LED turns on) must
repeat the procedure from point 1 (up to a
maximum of 30 transmitters);
6_ to memorise codes on the 2nd channel, repeat the procedure from point 1 using button P2 instead
of P1;
7_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
NOTE: if the maximum number of codes (30) is exceeded, LED DL7 flashes rapidly for about 3
seconds without memorising the code.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button P1 pressed for 3 seconds in order to cancel all the associated radio control devices;
2_ LED DL7 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ LED DL7 turns off for approx. 3 seconds and then remains steady to indicate that the code has
been cancelled;
5_ repeat the procedure from point 1 using button P2 to cancel all the associated radio control de
-
vices;
6_ to exit the learning mode without memorising a code, press button P1 or P2 briefly.
ATTENTION: TO memorise a code on a new type of remote control unit (e.g.: from dip-switch
to rolling code or vice-versa) both channels must be cancelled.
ENGLISH
