Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
41
DCCO 2500, 5500, 7500 and 10500
Maintenance
In order to increase the lifetime of your spreader and avoid the occurrence of
interruptions during operation, it is necessary to make a correct lubrication, as indicated
below.
1) Every 24 operating hours, lubricate the joints through the grease fittings in the
following way:
• Be sure about the lubricant quality, with relation to its efficiency and purity, avoiding
the use of products contaminated by water, earth and others.
• Remove the crown of old grease around the articulations.
• Clean up all grease fittings with a cloth before introducing the lubricant and substitute
the defective ones.
• Introduce an enough amount of new grease.
• Use grease of medium consistency.
•
CARDANS:
Grease the universal joints and verify if the tube and shaft are protected
with grease. (See "Periodic Maintenance" on pages 43 and 44).
•
BEARINGS:
Through the grease fittings, grease the bearings of transmission,
bushings, tandem articulation pin (double wheelset) and the conveyor bearings.
•
THREADS:
Apply grease on the thread of the gate adjusting rod and tighteners.
•
CHAINS:
Lubricate with oil and keep them tensioned.
Lubrication
Lubricate every 24 hours of service
