Marchesan Implementos e Máquinas Agrícolas “TATU” S.A.
52
DCA² MC 2500, 5500, 7500 & 10500
Maintenance
In order to reduce the friction caused by the moving parts of the equipment, carry
out a correct lubrication, as indicated below.
1) Every 24 hours of service, lubricate the joints through the grease fittings in the
following way:
• Be sure about the lubricant quality, with relation to its efficiency and purity, avoiding
the use of products contaminated by water, earth and others.
• Remove the remainder old grease around the articulations.
• Clean up all grease fittings with a cloth before introducing the lubricant and replace
the defective ones.
• Introduce an enough amount of new grease.
• Use grease of medium consistency.
•
CARDANS:
Grease the universal joints and verify if the tube and shaft are protected
with grease.
• Clean up the cardan every 15 days or before if necessary.
• Remove the protection covers.
• Separate the 'male' part from the 'female' one, wash and remove crusts, dry, lubricate
the sliding parts with grease and assemble again.
•
BEARINGS:
Through the grease fittings, grease the bearings of transmission,
bushings, tandem articulation pin (double wheelset) and the conveyor bearings.
•
THREADS:
Apply grease on the thread of the gate adjusting rod and tighteners.
•
CHAINS:
Lubricate with oil and keep them tensioned.
Lubrication
Lubricate every 24 hours of service
• Lubricate the points shown above and all grease fittings as well.
ATTENTION
Содержание DCA2 MC 2500
Страница 68: ...www marchesan com br...
