TATA Motors Nano, Руководство владельца и сервисная книжка

Страница: 74 / 94

72
ENGINE OIL LEVEL
ENGINE OIL TOPUP
Remove the oil filler cap and pour oil
slowly through the filler hole to bring
the oil level to the upper limit on the
dipstick. Be careful not to overfill. Too
much oil is almost as bad as too little
oil. After refilling, start the engine and
allow it to idle for about a minute. Stop
the engine; let the oil settle and check
oil level again.
ENGINE COOLANT LEVEL
Engine oil level should be checked
when engine is cold. Allow at least
30 mins. for engine oil to settle before
checking oil level.
1. For checking engine oil level, pull
out the dipstick from the engine
oil case, wipe it clean with a cloth
or a paper napkin.
2. Insert it again to its original
position.
3. Pull out the dipstick again and
observe the oil level on the
dipstick.
4. If the oil level is below the mid
point of min. and max. marks, top
up using recommended grade of
oil.
NOTICE
Oil level should not exceed the
max. Mark. Always check the oil
level when the car is on a level
ground and the engine in cold
condition.
1. Engine Filling Cap 2. Dip Stick
Check the engine oil level if “low oil
pressure” warning comes 'ON' while
driving. Failure to check the oil level
regularly could lead to serious
trouble due to insufficient oil.
The coolant level in the coolant no-loss
tank should be between max. & min.
marks. This can be viewed through a
translucent reservoir. If less, add
coolant up to the max. mark and refit
the cap properly.
MAINTENANCE
ENGINE OIL & ENGINE COOLANT