TATA Motors Nano, Руководство владельца и сервисная книжка

Страница: 29 / 94

27
HVAC & AIR CONDITIONING
AN OVERVIEW
NOTICE
When mist gets cleared switch
the knob "A” position to Face
mode.
In high humidity areas, if cold air
continues to flow over
windshield, it may cause sudden
fogging on outside surface of
windshield.
Defrosting : (Only on HVAC)
In low temperature areas, to clear
frost formation outside the
windshield glass, following settings
are used.
First start the engine and accelerate
to warm up.
Knob 'A' - Towards windshield
Knob 'B' - Maximum blower speed
Knob 'C' - Maximum hot position
Switch 'E' - Fresh mode.
Once the windscreen has become
clear, change to suitable setting.
NOTICE
If AC is not giving cooling effect
even when blower is ON and AC
request switch is pressed, get the
vehicle to the nearest authorised
service outlet.
High throttle demand or rapid
acceleration causes the
compressor cut off for few
seconds.
Ventilator :
Front Ventilators
Side Ventilators
The air flow can be adjusted
continuously with the rotary control
knob at the vents on the dash board.
The air vents can be adjusted upward
and downward.
NOTICE
Refrigerant charged in the air
conditioning circuit has been
identified on the label over front
body member. Use only
refrigerant as given in the label
for topping up or recharge, i.e. do
not charge the vehicle with some
other refrigerant than the existing
refrigerant. Always use R134a
(Non CFC) refrigerant.
Fresh air is taken from the grill
opening provided on the fire wall
under the front hood at base of
windshield glass outside the
vehicle. Keep these openings
clear and free.