TATA Motors nano genX, Руководство пользователя, Страница: 73 / 156

71 71
DRIVING
STARTING THE ENGINE (MT)
Starting the Engine
Before starting :
1. Apply parking brake.
2. Ensure gear lever in neutral.
A. Insert the key in steering cum
ignition lock and turn it to ‘ON’
position.
B. Press the clutch pedal fully.
C. Now crank the engine.
D. If the engine does not start turn
the key to off position and try after
2 mins.
NOTE
Vehicle should not be started by
pushing or towing. This starting
method could result in permanent
damage to the catalytic converter.
Use jump leads to start a vehicle
with a weak or flat battery.
NOTE
After starting run the engine in
idle speed for at least 30
seconds.
CAUTION
Running Engine under idle
condition for long duration and
also in high idle (fly-up rpm)
should be avoided
Starting a Cold Engine :
•
Engine which is started after 6
hours should be treated as cold
engine. For Electronic fuel
injection models.
•
With your foot off the accelerator
pedal, crank the engine by
turning the ignition key to
“START”. Release the key when
the engine starts.
•
If the engine does not start after
15 seconds of cranking, wait
about 15 seconds, then press
down the accelerator pedal to 1/
3 of its travel and try cranking the
engine again. Release the key
and accelerator pedal when the
engine starts.
•
If the engine still does not start,
try holding the accelerator pedal
all the way to the floor while
cranking. This should clear the
engine if it is flooded.
Running-in Period (MT) :
Avoid rapid acceleration and
prolonged high speed running of
the engine while using the new car
for the first 1000 km of operation.
Do not exceed the following road
speeds during running in period.
Gear Kmph
1 st 15
2
nd
25
3
rd
40
4
th
60