Tasselli PANDA H205, Руководство по эксплуатации и обслуживанию

Страница: 66 / 68

66
PANDA
USE AND MAINTENANCE MANUAL
428900224 237
EN
ALARM SIGNIFICATION PERSONNEL
AUTHORIZED
Sensor fault F1. In the case of adjusting the supply air:
Operation di’emergenza.
In the case of weighted adjustment:
Determining the actual value adjustment only with F2.
Sensor fault F1 and F2. In the case of weighted adjustment:
Operation di’emergenza.
Sensor fault F2. In the case of adjustment of the return:
Operation di’emergenza.
In the case of weighted adjustment:
Determining the actual value adjustment only with F1.
Sensor fault F3. The electric defrost, defrost hot gas or cold gas will not start.
Probe plausibility check. During the cooling mode, the supply air is warmer return or limiting probe is
warmer than the air fl ow sensor.
Note only in day mode; disappears into night mode.
Data error in nonvolatile
memory
In the event of a power failure at high energy, is possibileche the rated values
are corrupted. On the disturbed parameter overwrites the value of
defaults. Check out all the storage space and possibly make new entries! Insert
the controller without power.
EEV Pressure, pressure
transmitter module EEV
but faulty transmitter
refl ected ok
Pressure transmitter for superheat control module EEV defective.
If P89 is set to a valid connection number or an address bus CAN, the suction
pressure is reported by the CAN bus.
Error, no information on
the suction pressure.
Pressure transmitter for adjustment of superheat defective and no signal from
the pressure transmitter refl ection; EEV opens the degree of
emergency opening. (P102)
Temperature probe error
suction gas.
EEV opens with openness di’emergenza. (P102)
Address in bus collision
CAN.
The set address is already assigned.
Set another address for the device.
The message will disappear about 20 seconds after the fault is cleared.
Error CAN bus.
No CAN communication
bus.
Check the CAN bus connection or set to 0, the address.
Clock time is not
valid. (Real-Time-Clock)
Create a CAN bus connection to the gateway or enter the time and date (P16,
P67, P68) and set the address to 0 (P64)
Cell door open too
long.
Close the door of the cell, which may increase P76 “door alarm delay.
Viewing
fl ashing
Overtemperature or
temperature below the
actual value adjustment.
Control probe too hot or too cold.
Check le’impostazione the overtemperature threshold P47 or P48 under tempe-
rature.
Failure of communication
with the module EEV.
EEV module failure or connection to CD-XP interrupted.
When the EEV form is not working, EEV opens with the degree of openness of an
emergency. (P102)
When there is no EEV form, select the thermostatic expansion valve. (P86 = th)
Attachment 23 - CONTROL PANEL - CRD XP - Sheet 3 of 3