64
Cleaning start
Working with a flexible central steel pillar
Working with the scraper
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev
-
eral work steps.
Replenishing cleaning solvent
Empty recovery tank
Recovery tank full:
Stairs
• Pull on the adjusting lever (1) and ap
-
ply the adjusting lever lock (2).
As a result of this lock, the central
steel pillar (3) can be moved freely up
and down. The lock is released by
pulling on the adjusting lever again.
• Pull on the action lever to lower the
scraper.
The scraper is intended above all for
cleaning under tables and benches.
In this way, the residual water can be
scraped up by pulling the machine
backwards and will be sucked up
when traveling forwards again.
Notice:
More precise details regarding the direct
and indirect working method can be found
on the respective method sheet.
Please contact your TASKI customer con
-
sultant for further details.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Attention:
The flooring may be damaged when work
-
ing without cleaning solution.
Notice:
A rattling sound of the pump indicates that
the fresh water tank is empty.
Attention:
The pump must never run dry for an ex
-
tended period.
• The machine must be switched off.
1
2
3
• Open the tank lid.
• Fill the fresh water tank with water, see page 62.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 65.
Notice:
The machine must only be transported
over stairs by two persons.
• The machine must be switched off (main switch).
Attention:
Lifting the machine can be dangerous un
-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
Attention:
Both the freshwater and the waste water
tank must be emptied completely before
lifting the machine.
• To lift, grip the machine at the re
-
cessed grip by the squeegee while
the second person holds the ma
-
chine handle.