©Copyright Task Force Tips, Inc. 2002 - 2015
LIN-035 June 16, 2015 Rev15
5
3.2 SPECIFICATIONS
3.2.1 MECHANICAL
Maximum nozzle inlet pressure with
valve shutoff
300 psi
21 bar
Operating temperature range of fl uid
33 to 120º F
1 to 50º C
Storage temperature range
-40 to 150º F
-40 to 65º C
Materials used
Aluminum 6000 series hard anodized MIL8625 class 3 type 2,
stainless steel 300 series, nylon 6-6, nitrile rubber
3.3 NOZZLE COUPLINGS
Many inlet couplings such as NH (National Hose) or NPSH (National Pipe Straight Hose) can be specifi ed at time of order.
CAUTION
Nozzle must be mated to a hose line with matched threads. Mismatched or damaged threads may
cause nozzle to leak or uncouple under pressure and could cause injury.
CAUTION
Dissimilar metals coupled together can cause galvanic corrosion that can result in the inability
to unscrew the threads or complete loss of thread engagement over time. Per NFPA 1962, if
dissimilar metals are left coupled together an anti-corrosive lubricant should be applied to the
threads. Also the coupling should be disconnected and inspected at least quarterly.
3.4 USE WITH SALT WATER
Use with saltwater is permissible provided nozzle is thoroughly cleaned with fresh water after each use. The service life of the nozzle
may be shortened due to the effects of corrosion and is not covered under warranty.
4.0 FLOW
CHARACTERISTICS
The following graphs show the typical performance of MID-FORCE, CAFS-FORCE and DUAL-FORCE nozzles.
SPECIAL CONFIGURATIONS - If nozzles are made according to the special marking or performance requirements of the fi re
department then the operating characteristics may differ from the published data in this manual. Repair parts specifi c to each serial
number may differ from those shown in the service procedure. The required parts for each serial number are available on-line by
entering www.tft.123456 with the numbers corresponding to the serial number engraved on the product.