Page
11
of
29
Start with the
Setup tab
.
You can assign a
name
to any track for your convenience. For example, you could rename
Track 1 as “Boom”
Channel Link
is for linking a stereo microphone so that one set of controls spans over two input
channels.
MS Mic
mode is for when you are recording unprocessed mid-side tracks with an M-S
type mic.
The
TRIM GROUP tab
allows you to link the gain level of any input so that one track controller knob is
master over the group. For most film/video production, you would not use this feature.
The
INPUT tab
lets you select analog or digital input for each channel. If you are bringing in digital
sources, the Fs CONVERT button allows you to turn on a sampling rate converter. You can also activate
PHANTOM mic powering
for each input.
The
SIGNAL PROCESSING
tab allows you to reverse the acoustic phase of a given channel, to engage a
low cut filter, or to engage a limiter. You can dial in the variables for the low cut settings for each
channel by pressing the main
LowCut Filter
button on the left of the screen.
