TASCAM HS-8
13
PARALLEL connector
The
PARALLEL
connector on the rear panel allows external
control of this unit. The pin assignments are as follows.
Pin No.
Function
In/Out
1
GND
2
PLAY/Flash 1
In
3
STOP/Flash 2
In
4
RECORD/Flash 3
In
5
SKIP FWD/Flash 4
In
6
SKIP BWD/Flash 5
In
7
FLASH LOAD (STOP)
In
8
FADER START
In
9
FLASH Tally
Out
10
READY Tally
Out
11
RECORD Tally
Out
12
STOP Tally
Out
13
PLAY Tally
Out
14
REMOTE Select
In
15
PAUSE/Flash 6
In
16
CALL/Flash 7
InIn
17
AUX1/Flash 8
In
18
AUX2/Flash 9
In
19
AUX3/Flash 10
In
20
Flash Page
In
21
Reserved
22
CF1 Tally
Out
23
ONLINE Tally
Out
24
CF2 Tally
Out
25
+5V*
In: Command input, for transport control
Internal circuit, +5V pull-up
Operates with low commands of 50 msec or more
Out: Command output, for tally output
The internal circuit is open collector (output
impedance 10Ω)
Low command output when operating
20 V dielectric strength, 35 mA maximum current
*
+5V: 50 mA maximum supplied current
NOTE
The FLASH LOAD (STOP) (pin 7) functions are FLASH LOAD when
•
stopped and STOP during playback and when paused.
When Remote Select (Pin 14) is high, the input pins that have
•
two commands separated by a “/” (pins 2–6 and 15–19) in the
above table will perform the first-listed function, and can be
used as conventional parallel controllers.
When this pin is low, the above-listed input pins will function as
flash start keys. Moreover, the key assignments will be as follows
according to the high/low state of pin 20.
#14
#20
Flash-start take
Low
High
1–10
Low
Low
11–20
The following example is of a connection that uses a fader to
•
start and stop playback of this device.
START
STOP
Pin 1 GND
PARALLEL
Pin 8
FADER START
For information about the assignment of AUX1-3 (pins
17-19) functions, see the “PARALLEL tab” of the REMOTE
SETUP screen on page 48.
RS-232C Connector
The RS-232C connector on the rear panel can be
connected to an RS-232C connector on a computer to
allow control of this unit from that computer.
Makes settings related to communication on the REMOTE
SETUP screen RS-232C page. (See “RS-232C page” on page
48.)
NOTE
Please contact TASCAM customer support for information about
this unit’s RS-232C command protocol.
RS-422 connector
You can control this unit remotely by connecting the
RS-422 connector on its rear panel to a controller or editor
compatible with SONY P2 protocol (RS-422).
Make settings related to operation on the REMOTE SETUP
screen RS-422 page. (See “RS-422 page” on page 48.)
NOTE
Please contact TASCAM customer support for information about
this unit’s protocol compatibility.
2 − Names and functions of parts
Содержание HS-8
Страница 1: ...HS 8 8 Channel Audio Recorder D01106920A OWNER S MANUAL...
Страница 71: ...TASCAM HS 8 71 Notes...