Tarlan Technical Little Cracker, Руководство по установке

Страница: 9 / 23

Page 9 of 23 Rev B Mar 2012
11. We have a new spacer to hold the flu and 150mm liner parallel to each other – fit this to
flue and position it around 20mm from bottom edge of the 150mm sleeve. (In this
picture we assemble it, then slide it up inside the sleeve and then tighten bolt) spacer
comes as a flat unbent piece which needs to be bent by hand.
(insert bent spacer pic)
9. Cut the Dektite at the 140mm mark and fit, once positioned lift it up, put sealant under
the top lip and pull back down, then proceed to put sealant under the edge and rivet edge
flange to roof.