Target PRO 35 III DIESEL, Руководство по эксплуатации

Страница: 20 / 46

20
1A. KNOB: Use to tighten operator grip handles.
1B. HANDLE BARS: For operator gripping.
1C. FUEL TANK FILL: Fill the fuel tank at this
location.
1D. OIL PRESSURE GAUGE: Shows the engine oil
pressure
1E. WATER SAFETY SWITCH: Stops the engine if
the water supply to the blade is interrupted.
1F. VOLTAGE GAUGE: Shows the voltage of the
electrical system.
1G. FUEL GAUGE: Shows the level of fuel in the fuel
tank.
1H. ENGINE TACHOMETER: Shows the engine
RPM’s.
1J. BLADE DEPTH STOP: Sets the depth stop for
repetitive cuts at the same depth.
1K. BLADE DEPTH INDICATOR: Displays cutting
depth.
1L. ENGINE START SWITCH: Start the engine
using this switch.
1M. WATER PUMP SWITCH: Optional
1N. PARKING BRAKE (Optional): Pull up to lock rear
axle parking brake. Push down to release Parking
brake.
1O. WATER INLET:
1P. ENGINE THROTTLE:
1R. RAISE/LOWER SWITCH: Located on speed
control lever. Use to raise and lower the saw.
Push up to raise saw upward. Push down to lower
the saw.
1S. SPEED CONTROL LEVER: Controls forward
and reverse directions, stop, and the speed of the
saw.
1T. RED PALM SWITCH: For EMERGENCY STOP
of the saw. Stops all systems except lights, pull up
to reset. Do not use for routine stopping.
1U. WATER OUTLET:
1V. STOP POSITION: The saw will stop travel
movement when the speed control lever (1S) is in
this position. The engine will not start unless the
Speed Control Lever (1S) is in the STOP position.
1W. TRANSMISSION ENGAGE NEUTRAL KNOB:
Pull up to disengage transmission and push the
saw in freewheel wheel mode. Push down to
engage transmission and drive under power.
1Z. WATER VALVE:
FIG. 1
(PRO 65 III DIESEL SHOWN)