Targa 106751, Руководство пользователя и сервисное руководство

Страница: 162 / 189

CR 1.0 A1
160 - English
6. Press the – (17) or + (18) button several times to highlight the desired language and press
OK (12) to confirm.
7. When finished, press the Return button (16) to show the main menu.
Setting the date / time
The procedure described below only works when the Dashboard Camera is NOT
connected to the computer with the USB cable. If necessary, first disconnect the USB
cable from the USB/charge port (5) on the Dashboard Camera.
1. Power the device on by pressing and holding the On/Off button (14) for approx. 3 seconds.
2. Press the – (17) or + (18) button several times until the "Setup" Menu is displayed.
3. Press the OK button (12) to open the "Setup" menu.
4. Press the – (17) or + (18) button several times until the "Date/Time" option is selected and
press OK (12) to confirm.
5. Press the – (17) or + (18) button several times to set the value currently selected and press the
OK button (12) to apply it.
The cursor skips to the next field where you can set the corresponding value. Repeat this
procedure to set all values accordingly.
6. When finished, press the Menu button (11) to return to the Setup menu or press the Return
button (16) to open the main menu.
Turning on and selecting the operating mode
Once you have switched the device on (hold down the On/Off button (14) for approx. 3
seconds), there are three scenarios depending on whether and how the Dashboard Camera
battery is charged.
Dashboard Camera is not being charged
If the Dashboard Camera is not plugged in (USB or car charger) the "Loop recording" option from
the main menu will appear after switching the device on.

Select the "Loop recording" option in the main menu by pressing the OK button (12) to record
video in loop recording mode. See also "Loop recording" on page 170. Video recording will
now start immediately.

Alternatively, using the – (17) and + (18) buttons, select a different operating mode and
confirm by pressing the OK button (12).