Page 7
rev 3.0.03
6.1.3
Corrections for different transmitters
The template targets the X9D. If using a different transmitter, then CH18 and CH20 must be checked for the
correct source controls:
Channel
Mixer source
CH18:RawMot LS
CH20:Camber
RS
To check the mixer sources:
Open the
M
IXERS
menu
Scroll to required channel. Note the source. If incorrect, then:
□
Press
{
LONG ENTER
}
to open the mixer editor
□
Amend the source.
Tip:
You can use the dropdown menu, or simply move the control.
□
Press OK.
6.1.4
Familiarisation
Using the transmitter on its own, familiarise thoroughly with the following:
Arming and disarming the motor
with motor disconnected
(see Section 3)
Selecting Thermal, Cruise, Power, Speed and Landing modes (see Section 1.3)
Activating CAL mode and sub-modes (see Section 5)
Start/stop/reset integrated flight timer (see Section 4)
Verify that the sounds are working correctly. If not, check that the sound files are in the correct location.
6.2
Calibrating the servos
In this section you will calibrate the servos. The goals are:
Maximise travel
Achieve left/right symmetry
Linearise responses
All the adjustments in this section are made in CAL mode.
Correct calibration is essential for diff to work correctly, and for precise tracking of flaps with ailerons.
6.2.1
Set servo rotation
Switch on the transmitter (do not power up the receiver yet)
Crow stick to centre
Enter CAL mode, and set switch
SA
to middle.
Power up the receiver
Open the
OUTPUTS
menu
Set the rotation of each servo according to table below:
Stick command
Control surface
Notes
Aileron stick right →
RtAil goes up ↑
LtAil goes up↑
In CAL mode, the ailerons
move up
together
Thr stick forward ↑
RtFlap goes up↑
LtFlap goes up↑
V-TAIL only:
Ele stick forward ↑
RtVee goes up ↑
LtVee goes up ↑
In CAL mode, the elevator(s) operate in
reverse to normal
.
X-TAIL only:
Ele stick forward ↑
Ele goes up ↑
X-TAIL only:
Rudder stick right →
Rud goes right
