Functions, inputs & outputs
1 - IN:
Input of signal to be amplified. Connect the to the RCA output of the Head Unit using
good shielded cable to avoid noise interference.
HIGH PASS FILTER (HPF):
Variable setting from 10Hz to 90Hz, which determines the start of
the amplifier's operating frequency.
LOW PASS FILTER (LPF):
Variable setting from 90Hz to 8KHz, which determines the end of
the amplifier's operating frequency.
4 - CROSSOVER
5 - BASS BOOST
2 - OUT:
Audio signal output. Sends the same input (IN) signal to another amplifier, allowing
cascading.
3 - GAIN:
Adjusts the input sensitivity of the amplifier, allowing a perfect adjustment to the
output signal levels of various head units models on the market. It is possible to adjust from 4V
(minimum sensitivity) to 0.2V (maximum sensitivity).
FREQ.:
Set the frequency of bass boost from 35Hz to 55Hz.
BOOST:
Set the boost level from 0 to + 10dB at the frequency set in FREQ.
8 - SPEAKER:
SPEAKER: Output (positive and negative) for connecting transducers
(speakers). Follow the indicated polarity.
7 - TERMINAL REMOTE:
It must be connected to the remote output of the head unit using a
18 AWG cable.
6 - MONITOR:
Accessory connection that has the function of monitoring the amplifier,
displaying clipping and protection status.
(Included accessory)
.
For speaker associations, the impedance to consider is the resulting impedance:
09
ENGLISH
2
1
3
4
5
6
7
8
4 OHMS
4 OHMS
Resulting
impedance:
2 OHMS
Amplifier 2 OHMS
2 OHMS
2 OHMS
Resulting
impedance:
1 OHM
Amplifier 1 OHM
Содержание MD8000.1
Страница 1: ......
