Power supply connector
1 - FANS:
This amplifier has two internal ventilation fans. For perfect functioning, the amplifier must be
installed in a cool and aired place with at least 1” (25mm) space around the heasink for proper heat
spreading. The usually working temperature of amplifier is 65°C.
2 - POSITIVE POWER SUPPLY TERMINALS:
Use a 2/0 AWG (70mm²) cable directly from the positive
battery terminal with fuse (600A), as close as possible from the battery.
3 - NEGATIVE POWER SUPPLY TERMINALS:
A 2/0 AWG (70mm²) cable as short as possible must be used,
connected to the negative battery pole.
It is recommended that all cables must have tinned ends to improve electrical contact.
Blue LED steady on:
Indicates that the amplifier is turned on.
Power supply voltage greater than 16V.
Red LED steady on:
Short-circuit or impedance lower than that supported at output.
RED LED flashes 3x:
RED LED flashes 2x:
Blinking yellow LED according to music:
Indicates that the amplifier is operating at the
threshold of distortion. If the red LED also blinks, it indicates excessive distortion.
We recommend don’t turn off the amplifier, so that the cooling time will be shorter, through
the ventilation of fans.
Flashing yellow LED:
Excessive temperature (May be caused by obstruction of the internal fans,
improper installation or poorly ventilated location).
When the amplifier reaches the temperature of approximately 80°C (176°F), the thermal
protection starts working, the audio is interrupted and the yellow LED will start flashing. The fans
will be functioning, in order to cool down the components quickly. Only when the amplifier
reaches a safe temperature level, the audio is released and the amplifier gets back to its normal
functioning.
Supply voltage less than 9V.
LEDS indicators & protection systems
POWER
INPUT
Minimum 2/0 AWG (70mm²)
1
1
2
2
3
3
10
The fan and ventilation openings are responsible for cooling the amplifier when it is in
use, so it cannot be obstructed.
CAUTION
Before making any connections to the power terminals, make sure that the negative (-)
of the vehicle battery is disconnected.
CAUTION
Содержание MD12000.1
Страница 1: ...AMPLIFIER 12000WATTS 0 5 OHM 1 OHM ...
