Taramps DS 800X4, Инструкция по эксплуатации

Страница: 12 / 14

11
Installation
CAUTION: All connections to power supply, input and output connectors must be carried
out only with amplifier off.
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
It is compulsory to install protection fuses or circuit breakers as close as possible from batteries.
Output cables wire gauge_______________________________ ____________________15 AWG
Protection fuse or circuit breaker __________________________________________ _______60A
Remote cable ___________________ __________________________________________18 AWG
Caution: Using wire gauges below the recommendation will result in power loss and overheating
of wiring.
Positive / negative power supply cable ___________________ _______________________ 7 AWG
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
Recommended wire gauge & fuse
12V
CIRCUIT BREAKERS
10mm² (7 A
WG)
10mm² (7 A
WG)
Subwoofer
Woofer
Note: In case of horns and tweeters you must install a passive filter in the positive terminal of the
same ones (Consult transducer’s manufacturer manual).
At least 60Ah
Note: Required battery bank capacity:
*Illustrative images
Remote Cable 18 AWG
RCA Cable
Taramps
RCA Cable
Taramps
Head Unit
If the head unit doesn't have
the 4 RCA outputs, use ‘‘Y’’ type
cable adapters for properly 4
inputs connection of amplifier.
Connection example in the output: Bridged
4 ohms
2 ohms
DS 800X4 2
DS 800X4 1
4 ohms 4 ohms
2 ohms 2 ohms
DS 800X4 2
DS 800X4 1
4 ohms 4 ohms
2 ohms 2 ohms
DS 800X4 2
DS 800X4 1