Tar River Implements PRZ-3100, Руководство оператора

Страница: 18 / 76

18
Use only ISO VG 320 (ENI BLASIA 320)
gear oil (CINCINNATI MILACRON | DAVID
BROWN S1.53.101 (5E) | DIN 51517 Parte 3
- CLP | ISO L-CKD | U.S. STEEL 224)
).
IMPORTANT
To avoid pollution, it is absolutely forbidden to
dispose of oils, lubricants, filter cartridges or
other harmful materials into the environment.
Strictly follow the regulations in force for the
disposal of liquid and solid substances.
For what concerns the cardan shaft interventions,
refer to what is described in its use and
maintenance manual
E.3 Tine replacement
If tine replacement were necessary (worn or
broken), you must completely unscrew the
locking nut (
5 ), extract from its seat the fastening
screw ( 3 ) with its tine-stop plate ( 2 ) and then pull
the pair of teeth ( 4 ) from the equipment arm ( 1 ).
Insert a new pair and proceed in reverse order
the phases described for the removal.
E.4 Installation of tine-holder clamp (optional)
Protective clamp in case of breaking up of a tine.
To insert the clamp (
1 ) from the lower part, to
position it after the bending of the tines (as in
figure) and to stop it with the respective locking
screws and nuts (
2 ).
E.5 Troubleshooting
FAILURES CAUSES REMEDIES
Partial or insufficient forage harvesting Tines too high from the ground
Adjust working rotary unit tilt (see
paragraph page 16)
Tines rapid wear out
The tines are continuously in contact
with the ground
Adjust working rotary unit tilt (see
paragraph page 30)
1
2