Tar River Implements PRZ-3100, Руководство оператора

Страница: 14 / 76

14
- remove the cardan shaft protections;
-
pull out the two halves that make up the
shaft and attach one half to the hay
tedder PTO, triggering the safety spring
pin, and the other half to the tractor PTO,
also triggering the safety spring pin;
- place the two halves one next to the
other and find the minimum flowing
length (
L ). If the shaft is too long, first cut
in equal measures the two external
plastic protection tubes and then the
internal metal ones. File the cut parts
and lubricate the internal parts.
IMPORTANT
When the cardan shaft is pulled out to the
maximum, the two tubes must overlap by
at least 15 cm. When it is inserted at the
maximum,
the minimum backlash
allowed must be 4 cm.
-
remove the two halves of the cardan shaft
from their joints (on the tractor and on the
hay tedder) and reconstruct the shaft,
putting one half in the other completely;
-
connect again each end of the cardan
shaft to the respective PTO triggering their
safety spring pins;
-
block the protection tubes with the special
chains, respectively, on the hay tedder
and on the tractor in order to prevent
them from rotating. The overlap between
the guard and the cardan shaft must not
be less than 5 cm.
At this point, without activating the tractor PTO,
the equipment can be transported to the place of
use.
Note: if the equipment is used with a different
using the tractor, the cardan shaft may need a
readjustment. Proceed with the instructions
described in this paragraph.
C.5 Removal
For the hay tedder removal from the tractor follow
the instructions contained in the previous
paragraph, in reverse order.
C.6 Storage of hay tedder
The Customer must provide, within his company,
the equipment storage area, making sure it has a
wide and easy access. For the hay tedder
storing, the following interventions are needed:
-
if not already done, place the hay tedder into
transport configuration;
-
put the bearing feet (front and rear) for the
parking phase;
-
park the equipment in a safe and secluded
area, on a flat and solid surface;
-
remove the tractor from the hay tedder;
-
protect the equipment with a cloth.
MAX
MIN
Min 4 cm
Min 15 cm
cm 5