Tapworks NSC9PRO, Руководство пользователя и инсталлятора

Страница: 6 / 13

11
Please Remember – Only use tablet or pellet salt in your softener!
10
Connecting to electrics Programming the water softener
ELECTRICAL INSTALLATION
The water softener works on a 24 volt, 50 Hz
electric power supply. You must use the transformer
supplied into a 240 volt outlet only. Be sure that
the electrical outlet you plug the transformer into
is inside, as the transformer is not designed for
outdoor use. To connect the transformer to the controller
board, push the female end plugs on to the male
connectors as indicated below.
Should the faceplate fail to display or indicate
an error code, please check that the connections
are as per the diagram below. You will need to
remove the valve cover to do this.
PROGRAM THE SOFTENER
When the power supply is plugged into the
electrical outlet, the model code and a software
version number (example: J3.9) are briefl y shown
in the display. Then the words “PRESENT TIME”
appear and 12:00 begins to fl ash.
SET PRESENT TIME OF DAY
If the words “PRESENT TIME” do not show in the
display, press the OK button a few times until they do.
1 Press the
▲
UP or
▼
DOWN buttons to set
the present time. Up moves the display ahead;
down sets the time back.
NOTE: Press buttons and quickly release to slowly
advance the display. Hold the buttons down for
fast advance.
2 When the correct time is displayed, press the
OK button, and the display will change to
show the “Hardness” screen.
SET WATER HARDNESS NUMBER
If you completed the previous step, the word
“HARDNESS” should show in the display. Otherwise,
press the OK button several times until it does.
1 Press the
▲
UP or
▼
DOWN buttons to set
the hardness of your water supply, in grains
per gallon. The default is 25.
WATER HARDNESS
ppm Unit setting
(170) 10
(190) 11
(200) 12
(220) 13
(240) 14
(255) 15
(270) 16
(290) 17
(300) 18
(325) 19
(340) 20
(360) 21
(380) 22
(400) 23
(420) 24
(440) 25
(460) 30
(480) 30
(500) 35
BACK OF
FACEPLATE
Transformer
240V Power
Source
Connect here
to direct to the
faceplate, either
way round
Motor
Sensor
NO
NC
SET SALT
LEVEL button
UP button
TANK LIGHT
button
OK button
RECHARGE
button
DOWN button
LOW SALT
indicator
Display