7
Please Remember
– Only use tablet or pellet salt in your softener!
6
Water softener plumbing connections
Connecting the water softener
to the home’s plumbing
MAKE SURE THE INLET AND OUTLET HOSES ARE CONNECTED CORRECTLY TO
THE PLUMBING AND TO THE INLET OUTLET POINTS OF THE BYPASS.
FAILURE TO FIT THE HOSES CORRECTLY CAN DAMAGE THE WATER SOFTENER.
Note:
If you need to remove the valve cover
for ease of installation, remove the salt lid, then
simply release the two catches behind the valve
cover and tilt top end towards you slowly, taking
care not to pull off the wire connections.
Please note
that the valve cover is connected
to the valve motor, so cannot be removed fully.
PLUMBING
Turn off the water supply at the incoming mains.
Note:
The non-return-valve is already fi tted in the
integrated bypass.
FITTING THE HOSES TO THE BYPASS
AND PLUMBING
The hoses come with a standard push-fi t. Unlock
the screws on bypass and fully push the hoses into
the inlet and outlet points of the bypass. To secure,
twist the nut until the gap is closed to secure the
hose in position.
You may want to connect hoses to the plumbing
fi rst before securing hoses in position.
FITTING THE BYPASS TO THE
WATER SOFTENER
Fit the bypass into the water softener’s inlet and
outlet points. ONLY FIT WITH HOSE INLET/
OUTLET FACING DOWN.
Secure the bypass with the two large adaptor clips,
from the top down. Be sure they snap fi rmly into
place so that the bypass will not pull out. Pull on the
bypass to ensure a tight fi t has been achieved.
It is important to fi t correctly otherwise
the water softener can be damaged.
CONNECT HOSES TO THE PLUMBING
Connect hoses to the plumbing using standard
plumbing connections.
On the bypass, if not already done, secure hoses
by twisting the nut until the gap has closed.
Make sure the bypass is open to allow water into
the house while fi nishing installation. (‘Hard’ is the
top position on the bypass – see page 8)
Turn on mains water.
OUTLET
OVERFLOW
INLET
DRAIN
Содержание NSC9PRO
Страница 12: ...22 Notes...
