TapFlo DT Series, Оригинальная инструкция

Страница: 17 / 35

3. MAINTENANCE
IOM manual active pulsation dampeners
17
3.6. Assembly of the dampener
The assembly procedure is done in the reverse order to the disassembly.
Nevertheless there are a few things that you have to remember in order to assemble the
dampener correctly.
Fig. 3.6.1
Using a screwdriver, insert the O-rings [47] into the
dampener block [12].
Fig. 3.6.2
Using a pair of pliers, insert the seals [36] into the
dampener block [12]. To make the procedure easier
bend the seals into a kidney shape and then fit them
with a screwdriver.
Fig. 3.6.3
Push the shaft [1651] into the dampener block [12].
Fig. 3.6.4
Screw the shaft ending [1652] into the diaphragm
[15].
NOTE It is very important to screw the shaft
ending(using an allen key) as deep as possible so it
won’t have the tendency to unscrew during operation
Fig. 3.6.5
Screw the diaphragm [15] with the shaft ending
[1652] onto the shaft [1651].
NOTE! When the diaphragm is screwed in the holes
in the diaphragm must be aligned with the holes in
the block.