4
ACCESSORIES FOR YOUR “WINDY” SP PORT-O-BRAKE
®
Pro-Coiler
™
The portable coil holder that
becomes an integral part of your
“Windy” SP Port-O-Brake
®
• Keeps the coil off the ground and always
in front of you
• Helps ensure you get straight cuts all the time
• Helps increase production and eliminate waste
• Holds 24” wide by 100ʼ coil
Hooks on and detaches in seconds.
Allows you to roll out and cut coil
squarely to your exact length.
Change coils quickly by simply un-
hooking Roller Clip at one end and
inserting new coil.
Leg Tubes
Mounting
Plate
U Clamp
Mounting
Plate
Channel
Leg
Plate
36
1
/
2
”
Center of
Brake
3
Set legs onto Brake with leg tubes near drilled pilot
holes. Place “U” clamps over leg tubes, align holes and
install sheet metal screws. Drill re-maining holes through
clamps and install screws. Install screws also in mounting
plates as shown.
1
Position leg plates into
mounting plate channels,
align holes and install nuts and
bolts provided.
36
1
/
2
”
36
1
/
2
”
Drill
Drill
Drill
Drill
U Clamp
Mounting
Plate
Center of Brake
2
Invert Brake. From center of Brake,
measure outward along each rail
36
1
/
2
” and drill one pilot hole in center of
each rail using an 11/64” drill bit.
Installing the Light Duty Folding Legs
Rail
36
1
/
2
”
“Windy” SP Port-O-Brake
®
with optional accessories:
Pro-Coiler
and
Light Duty
Folding Legs
