9
REPLACING THE VINYL PROTECTO STRIP
Loosen Vinyl Protecto Strip
Push Vinyl Strip from one end by tapping
on the edge of upright screwdriver as
indicated. Make sure opposite end of slot
is free of dirt and obstruction.
CAUTION
:
Avoid hitting hinge with hammer.
Remove Vinyl Protecto Strip
Grasp other end of strip with pliers and
pull Protecto Strip out of slot. Check
slot for burrs, metal chips, dirt, etc. and
clean if necessary.
Drill Out “Center Punch” Marks
Clean out slots that hold Vinyl
Protecto Strip at both ends of Brake
using #26 drill bit.
Tools needed: drill, #26 drill bit, hammer, slotted screw driver, light oil, pliers or vice grips, center punch, and safety glasses
2
3
4
Replace Vinyl Protecto Strip
Replace Vinyl Protecto strip by lightly lu-
bricating leading end with small amount of
oil while sliding into slot. Wipe off excess
afterwards.
5
Punch Vinyl
When Vinyl Protecto Strip is in place
“center punch” both ends to prevent slip-
page.
6
Close Brake
Move Locking Handle to left.
1
REPLACING THE STAINLESS BENDING EDGE
Loosen Stainless Edge
To loosen old Stainless Bending
Edge, insert screwdriver behind one
end as indicated and twist to release
from end.
Remove Stainless Edge
Grasp one end of Stainless Bending
Edge with pliers or vise grips and pull
away with a twisting motion.
Note:
Stainless Bending Edge is not reusable
after removal.
Install New Stainless Edge
Starting on end away from Locking
Handle align new Stainless Edge flush
with end of Clamping Bar and tap into
place sideways with Rubber Mallet.
After replacement, “Center Punch”
Stainless Bending Edge on ends to
prevent possible sliding.
Open Brake
Move Locking Handle to the right.
Tools needed: slotted screwdriver, rubber mallet, vice grip or pliers, center punch, hammer, and safety glasses
1
2
3
4
5
