Tanita BC-G02, Руководство пользователя

Страница: 21 / 24

en
21
If the following problems occur ...then...
Refer to “Changing the Weighing Unit” on p.8.
Note: Your settings are not erased from the memory when you remove the batteries.
Your personal data has not been programmed. Follow the steps on p.7.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with
the guides on the measuring platform.
Reading cannot be obtained if the weight capacity is exceeded.
Troubleshooting
• The wrong weight format appears followed by kg, lb, or stlb.
• “Lo” appears on the display, or all the data appears and immediately disappears.
• “Err” appears while measuring.
• The Body Fat Percentage reading does not appear or “Err” appears after the weight is measured.
Batteries are low. When this message appears, be sure to replace the batteries immediately since weak
batteries affect the accuracy of your measurements. Replace all the batteries at the same time with new
AA-size batteries.
Please stand on the monitor and keep as still as possible.
The monitor cannot accurately measure your weight if it detects movement.
The monitor cannot take measurements if the Body Fat Percentage is higher than 75%.
• “OL” appears while measuring.
The personal data settings are not complete.
You need to measure body composition once immediately after entering the personal data.
• Cannot measure body composition even though personal data is set.
Set the target weight.
Press the DIET button while the weight is being displayed.
• The target weight information is not displayed even when the DIET button is pressed.
Set the diet mode for females. Also, enter the menstrual cycle start date every month.
• Diet mode for females information is not displayed even when the DIET button is pressed.
Is an electrical device that emits radio waves being used near this monitor?
Was the monitor stored standing upright or with items placed on top?
Did you move the monitor just prior to measuring?
Did you move the monitor immediately after measuring?
Measurement results and target setting values are not saved.
• "Err " appears.
The menstruation starting date has not been registered for a while.
Register the menstruation starting date.
• " " and "CYCLE" are displayed after the measurement results screen.Or the " " flashes in the measurement item screen.