T&S equip 098-014508-45, Инструкция по установке и обслуживанию

Страница: 6 / 28

6
Instructions
TENSION ADJUSTMENT
CAUTION: Always leave at least 1-2 turns between full extension and
when the spring is wound tight. If entire hose cannot be pulled out,
decrease tension until full extension is possible. Failure to test for
adequate spring revolutions can cause damage to reel. Hazards or
unsafe practices may result in minor personal injury or product or
property damage.
• Reels shipped with hose are pre-tensioned at factory. Reels shipped without hose
are pre-tensioned after installing hose, but before making final hose or inlet
connections.
• (Fig. 8) To pre-tension hose reel,
pull hose out to allow one full wrap
of hose to be looped back over
drum assembly. Hold drum from
turning by engaging ratchet (fig. 6),
and loop hose back on drum.
Repeat until desired tension is
acheived. After tension is set,
pull out hose. If full extension is
not possible, remove pre-tension
turns as needed by reversing process.
Service
CAUTION: Remove all tension before servicing. Hazards or unsafe
practices may result in minor personal injury, product or property
damage.
CAUTION: Do not utilize chemicals in the hose &/or the reel.
Chemicals can cause premature failure of the hose &/or the seals.
WARNING: Before performing any service, always disconnect and lock
out compressed air or fluid, and remove all spring tension. Hazards
or unsafe practices could result in severe personal injury or death.
HOSE INSTALLATION AND REPLACEMENT
• Remove all tension from reel (see “Tension Adjustment”). Remove hose-
stop (unwind hose from reel), remove strain relief (8mm nut) and unscrew
hose from swivel (round body is 24mm hex or, square body is 27mm hex).
Feed new hose through roller guide and through slot in flange. Then
connect hose to swivel (use thread tape or sealant), wind onto drum assembly, and
re-tension reel.
Fig. 8