2
Mechanical Installation Internal Tape Drive
For mechanical mounting specifications, please refer to
Figure 1
.
Allowed mounting position is either horizontal with the indicator LEDs to the
right, or vertical with the LEDs up.
The drive occupies a half-size 5.25-inch slot with standard holes for mounting
screws on both sides of the drive chassis and at the bottom of the drive.
Figure 1
Mounting specifications
Important!
Mounting screw
requirements
•
Only M3 (metric) screws must be used for mounting the drive
•
Maximum permitted screw penetration:
2.5 mm
•
Minimum required screw penetration:
2.0 mm
•
Screw torque, mounting screws:
0.5 Nm
•
Screws are supplied with all the Tandberg 220/420/820LTO drive
variants
•
Bags with 4 screws and 4 SCSI ID jumpers are available
(Ordering no. 43 32 65)
Do not use longer screws or higher screw torque than specified!
Figure 2
Allowed mounting orientations
