49
TANDBERG
FieldView Administrator Guide
D14098.02 June 2008
backlight is one step below maximum. Setting the backlight level higher will
reduce battery life
Lowering the backlight to minimum whenever the viewfinder is not needed.
•
This can be done quickly by pressing and holding the
Display
button for at
least two seconds. Press and hold it again to restore the current backlight
level
Improving the WLAN signal reception to minimize number and length of
•
wireless packet transactions
Disabling the radio if it will not be used
•
Reducing unnecessary use of illumination
•
Reducing unnecessary use of zoom
•
Reducing the speakerphone volume.
•
SD Cards
Always use SD cards that conform to the requirements outlined under
Secure
Digital (SD) Slot
in
Chapter 2
.
Note:
Never remove an SD card while recording or playback is active. File or
SD card corruption may result.
SD Format
All SD cards used with the TANDBERG FieldView Device must be formatted
in the TANDBERG FieldView Device. This includes cards that are labeled
“preformatted.”
Note:
Failure to format the SD card using the TANDBERG FieldView Device
may result in poor or erratic performance and may cause file corruption or file
loss.
To format an SD card from the File Browser:
Insert the SD card into the TANDBERG FieldView Device.
1.
Select
2.
File Browser
from the Main Menu.
Tap
3.
Storage Card
at the top of the folder pane in the file browser window.
4.
When Storage Card is selected, the
Format
button will be available in the
controls list. See Fig. 8-2.
Tap
5.
Format
and follow the on-screen directions.
Do not remove the card until formatting is complete.
The time required to complete the format operation is dependent on the
size of the card. For example a 1 GB card takes approximately 5 minutes.
Preventative Maintenance
The TANDBERG FieldView Device requires little preventative maintenance.
Follow the recommendations outlined in the TANDBERG FieldView Device User
Manual and the following guidelines.
General Recommendations
Do not expose the TANDBERG FieldView Device to dust, rain, or moisture.
•
Protect the TANDBERG FieldView Device from temperature extremes. Do
•
not leave it on an automobile dashboard or on top of a heat source.
Fig. 8-2 File Browser
Chapter 8
