Tanaka TCG 40EAS P, Инструкции по безопасности и руководство пользователя

Страница: 12 / 56

12
How to use the shoulder harness
Wear the shoulder harness on your shoulder as
shown Fig. 22 and hook it on the hanger of the
machine. Adjust the length of the shoulder harness
to the most comfortable position. (Fig. 22)
To remove the machine from the shoulder harness,
hold the main pipe of the machine fi rmly by one
hand and then remove the hook (20) of the shoulder
harness from the hanger (21). (Fig. 24-a)
19
20
21 24
20
22
23
19
a b
Fig. 24
How to reinstall the hook after using the
emergency release pinch
It needs to go through the buckle (22) of the hook
(20) to the metal plate (23) on the harness and go
through the plate (24) of the emergency release
pinch to the metal plate (23) on the harness.
(Fig. 24-b)
After installing the buckle onto the harness, pull the
hook (20) and make sure the hook (20) is securely
fi xed on the harness, then hook it to the hanger (21).
(Fig. 24-a)
WARNING
●
When using the machine, wear the shoulder
harness and hold the machine correctly with
both hands.
If you feel that there is something
dangerous, separate the brush cutter from
your body by pulling the emergency release
pinch (19) of the harness to the direction of
the arrow shown in Fig. 24-a.
●
If the cutting attachment should strike
stones or other debris, stop the engine and
make sure that the attachment and related
parts are undamaged. When grass or vines
wrap around attachment, stop engine and
attachment and remove them.
NOTE
If you pull the emergency release pinch without
holding the machine, the machine will fall to your
feet. Pull the emergency release pinch while
holding the main pipe of the machine by one
hand.
Before operation, make sure that the emergency
release pinch on the shoulder harness is working
properly.
Stopping (Fig. 25)
Decrease engine speed and run at an idle for a few
minutes, then turn o ff ignition switch (14).
14
Fig. 25
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or power control is released. When the
unit is turned o ff , make sure the cutting
attachment has stopped before the unit is
set down.
How to use nylon head
When cutting, operate engine at over 6500 rpm.
Extended time of low rpm may wear out the clutch
prematurely.
This product is designed so that it will stop cutting
when the nylon line becomes 6-5/16 ˝ (16 cm) or
longer.
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or power control is released. When the
unit is turned o ff , make sure the cutting
attachment has stopped before the unit is
set down.
Set the engine speed as low as possible and tap
the Head on the ground. (Fig. 26) Also, you can
extend nylon line with hands but the engine must be
completely stopped. (Fig. 27 )
Adjust nylon line to proper length 4-11/32 ˝ – 5-1/2 ˝
(11-14 cm) before each operation.
Fig. 26
000Book̲TCG40EAS(P)̲̲US.indb 12 000Book̲TCG40EAS(P)̲̲US.indb 12 2009/11/27 17:15:50 2009/11/27 17:15:50