14
English
15
4
˝
(10 cm)
Fig. 22
(4) Push each line into the stopper holes (16),
leaving the loose ends approx. 4
˝
(10 cm) in
length. (Fig. 23)
16
4
˝
(10 cm)
4
˝
(10 cm)
Fig. 23
(5) Insert both loose ends of the line through the
cord guide (17) when placing the reel in the case.
(Fig. 24)
17
18
Fig. 24
NOTE
When placing a reel in the case, try to line up the
stopper holes (18) with the cord guide (17) for
easier line release later.
Gear case (Fig. 20)
Check gear case or angle gear for grease level
about every 50 hours of operation by removing the
grease
fi
ller plug on the side of gear case.
If no grease can be seen on the
fl
anks of the
gears,
fi
ll the gear case with quality lithium based
multipurpose grease up to 3/4. Do not completely
fi
ll
the gear case.
Fig. 20
CAUTION
●
Make sure to remove any dirt or grit when
attaching the plug to its original position.
●
Before attempting inspection or maintenance
of the gear case, make sure the case has
cooled.
Semi-auto cutting head
Nylon line replacement
(1) Remove the case (14) by
fi
rmly pushing inward
the locking tabs with your thumbs as shown in
Fig. 21
.
14
Fig. 21
(2) After removing the case, take out the reel and
discard the remaining line.
(3) Fold the new nylon line unevenly in half as shown
in picture.
Hook the U-shaped end of the nylon line into the
groove (15) on the center partition of the reel.
Wind both halves of the line on the reel in the
same direction, keeping each half of the line on
its own side of the partition. (Fig. 22)
000Book̲TCG24ECP(SL)̲NA.indb 14
000Book̲TCG24ECP(SL)̲NA.indb 14
2016/02/04 9:59:55
2016/02/04 9:59:55
