Tanaka AD-6, Инструкция по эксплуатации

Страница: 37 / 45

- 36 -
11 Inspection and Post-sale Service
11.1 Periodic Maintenance
This tester is fully inspected and calibrated prior to shipping, and should require no
readjustment immediately upon delivery.
To ensure high performance and maximum safety, however, the tester needs to be
maintained and adjusted periodically. For the detail, refer Maintenance Manual.
11.2 Consumables and Accessories
!
Caution: Use only Tanaka Scientific Limited genuine
consumables, parts and accessories or such parts as
recommended by Tanaka Scientific Limited.
For an order or inquiry about consumables, accessories, or other replacement parts for this
tester, contact the authorized Tanaka distributor given in the warranty at the end of this
manual.
When placing an order, be sure to quote the product model "AD-6".
The most commonly used consumables and accessories are listed in Table 2: and
Accessories for Model AD-6.
Table 2: Consumables and Accessories for Model AD-6
▪ Graduated cylinder assemblies: 100 ml
・
200 ml (net: 186 ml)
▪ Distllation flasks: 100 ml ▪ 125 ml ▪ 200 ▪ 250ml
▪ Flask support boards: Ø25, Ø32, Ø38, Ø50, Ø70 hole
▪ Roll paper (thermal paper for built-in printer)
▪ Temperature sensors: For fuel oil ▪ for BTX
▪ Thermofuse: 5 pcs/Pack
▪ Temperature Sensor Centering Device for 125 ml flask
▪ Dry Point Sensor with Centering Device for 125 ml flask
▪ Dry Point Sensor with Centering Device for 200 ml flask
▪ Silicon Stopper, No.0A with hole for vapor tube
▪ Silicon Stopper for Condenser Tube Cap
▪ Heater Coil 100/120V 800W or 220/240V 1kW