tams elektronik 43-02345, Руководство пользователя

Страница: 9 / 40

tams elektronik
WD-34 | WD-34.2 | WD-34.M English

To make a good soldering joint you must use a clean and unoxidised
soldering tip. Clean the soldering tip with a damp piece of cloth, a
damp sponge or a piece of silicon cloth.

Cut the wires after soldering directly above the soldering joint with a
side cutter.

After placing the parts, please double check for correct polarity.
Check the PCB tracks for solder bridges and short circuits created by
accident. This would cause faulty operation or, in the worst case,
damage. You can remove excess solder by putting a clean soldering
tip on the spot. The solder will become liquid again and flow from
the soldering spot to the soldering tip.
Page 9