tams elektronik 43-02345, Руководство пользователя

Страница: 34 / 40

tams elektronik
English WD-34 | WD-34.2 | WD-34.M
Name of CVs CV
-
no.
Input value
(Default) Remarks and tips
Configuration
data 1
→ WD-34
29 128, 136
(136)
RailCom off 128
RailCom on 136
Configuration
data 1
→ WD-34.2
→ WD-34.M
29 0, 8, 128, 136
(136)
RailCom off 0
RailCom on 8
Operation via
turnout addresses 0
locomotive addresses 128
Advice: When RailCom is not used it is recommended to switch it off in CV#29.
Configuration
data 2 33 0, 1, 2, 3
(0)
The input value has to be calculated
by adding the numerical values
assigned to the desired parameters.
RailCom check on
0
RailCom check off 1
Central unit does not send coil-off 0
Central unit sends Coil-off
2
In standard operation the decoder checks directly after having been switched on if the booster
for the connected section supplies a RailCom cutout. In case faulty detections are mounting
the RailCom check should be switched off. This has no effect on the feedback with RailCom.
The central unit sending a coil-off-signal or not has direct effects on the on-time (see CV#3 to
6). In order to set the minimal switching time properly, it is important to set in CV#33 if the
central unit in use sends this signal or not.
Examples for central unit
not sending a coil-off-signal: Intellibox from Uhlenbrock, central
units from Lenz.
Examples for central unit sending a coil-off-signal: MasterControl from Tams.
Page 34