tams elektronik 43-02345, Руководство пользователя

Страница: 30 / 40

tams elektronik
English WD-34 | WD-34.2 | WD-34.M
8. Programming the decoder
You can program the configuration variables (CV) using a DCC digital
central unit. See the chapter in the manual of your central unit where
the byte wise programming of configuration variables (CVs) is
explained.
When using a Motorola central unit you can set the decoder address
with a programming jumper (WD-34) or with a programming push-
button (WD-34.2 and WD-34.M). Changing the other decoder´s
features or assigning a locomotive address is neither necessary in
layouts run in Motorola format only nor possible with Motorola central
units.
8.1. Programming decoder addresses
You can set the decoder address either by programming the CVs with
your DCC central unit or by using the programming jumper or push-
button. When setting the decoder address it is of no importance if you
intend to operate the decoder by vehicle decoder commands
(locomotive commands) or accessory decoder commands (turnout
commands).
The accessory decoder address used to send the switching commands
result from:
Decoder address x 4
= highest address of the quadruple accessory decoder address block
When operating the decoder by locomotive addresses, you use the
function keys F1 to F4 to switch the connected solenoid accessories.
Page 30