Film Thickness
Temperature
Speed
1.5 Mil (38 Micron) 110°C (230°F) 4
3 Mil (75 Micron)
110°C (230°F) 3
5 Mil (125 Micron) 125°C (257°F) 3
10 Mil (250 Micron) 135°C (275°F) 3
LAMINATING PROCEDURES
1. Push the handle to “DOWN” position to engage the rollers. Make sure the motor switch is in
“RUN” position. The user can now start laminating or mounting as the machine starts feeding in
film.
2. To put the lamination temporarily on hold without turning off the machine, the user can turn the
motor control switch to “STOP” position. This will cause the motor to stop running and the film
will stop feeding.
3. To resume the lamination job, turn the switch back to “RUN” position again.
(2) ONE-SIDED LAMINATION
LOADING THE FILM
Unpack only the upper rod. Install nylon, BOPP or even thermal film by following an
adapter---film---adapter sequence onto the rod and fit the adapters onto the paper core. Leave equal
lengths of the rod out of each end. Use the guide to position the roll of film then tighten the screw on
the adapter to secure the roll film. Load the rod on the laminator.
*Note: BOPP film is mainly suitable for 1-sided lamination on mounting boards or thick print sheets
as it has a natural tendency to curl even with very little heat. For best results on 1-sided
lamination without mounting, we recommend using nylon or thermal film for this application.
THREADING THE FILM
Refer to threading diagram for one side lamination. Do not mistake the reinforcing bar for the idler
roller.
1. Please pull the handle to the “UP” position to release pressure on all the rollers, then thread the film
through the upper hot rollers & pull rollers.
2. Thread the film by the rollers and make sure the film is perfectly aligned.
