ADJUSTING THE TEMPERATURE & SPEED
1.
User should set up the temperature for upper and lower rollers separately. Turn on the power switch
and press the “U” key, then the digital screen display will show the previous temperature setting of
upper roller.
Please adjust the temperature to the recommended setting based on the thickness of
film being used by pressing the “TEMP/SET” “
︿
” or “
﹀
” arrow keys.
Similarly do the same way
to set up the temperature of bottom roller by pressing the “L” key.
Said recommendations are found
in front of the machine’s left side panel.
The digital screen display will beep showing the set
temperature for about 3 seconds before showing the actual machine temperature.
NOTE:
To check the current temperature or temperature setting of upper or lower roller, please
press the “U” or “L” key.
2. Once the set temperature is achieved and the roller temperature is stabilized, the machine will start
beeping and the ready light will turn on. Once the ready light stays on, you can set the
recommended speed.
3. Press the “MOTOR” “
︿
” or “
﹀
” arrow keys to set the motor speed. The following table gives some
common temperature/speed setting for typical uses.
