Tally Dascom 2810, Руководство пользователя

Страница: 36 / 168

Options and accessories User Guide
Messages in the LC display
If the printer detects an internal fault or user error or if it expects you to do
something, a message will appear in the LC display. It also displays the status
during an operation (e.g.
Initializing ). Below you will find a list of messages with
brief descriptions of each message. The messages are described in greater detail
in the chapter Error messages via the display.
Message Meaning
Eject error The printer cannot eject the paper/advance it to park
position.
Hardware Alarm Internal hardware error. Try power cycling the printer. If
the message appears again, contact your dealer or
service technician.
Initializing
This message appears during the printer’s initializing
phase after switching on the printer.
Load error The printer cannot draw in the loaded paper.
Load paper from The printer has detected paper end during
operation/printer was switched on with no paper loaded.
Loading default Factory defined parameters will be reloaded in all
available menus after switching on the printer.
Out of paper
The printer has detected paper end during operation /
printer was switched on with no paper loaded.
Paperwidth error
Print characters override the detected right paper margin.
Parity error A parity error during data transmission is indicated.
Park position Paper is not being fed into print position.
Press any key The user is requested to press any key.
PW sensor defect The automatic paper width detection cannot detect the
left paper margin.
Selftest
After power-on, the printer executes a short hardware
self-test.
Tear Paper off
The user is requested to tear off paper which has been
advanced to the tear edge.
AED Error AED sensor cannot locate paper transport holes (only if a
cut device is installed).
Key functions when turning on the printer
If you keep one of the following keys pressed during power-on until the printer
has completed initialisation, the corresponding function is activated:
28