Area of Rescue Command Unit
Installation Guide
Model AOR-5 / Model AOR-10
Page
18
of
23
Rev. 4/13/2022
Copyright 2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
VIII.
Operating Instructions
1.
General Information
When the push button on the AOR-CSE Station is pressed, it will automatically either ring the
Command Unit handset, the Sub-Command Unit(s), or dial out using the phone line connected
to the
PSTN Line
terminal.
When a call comes in to the
AOR-5 / AOR-10 Command Unit
, an LED will light indicating
which AOR-CSE Station is calling in. If a call is already in progress, any other calls which
come in will cause the appropriate LED to blink to indicate they are awaiting an open line
—if
recorded and configured, the “On Hold” voice message will also playback at the AOR-CSE
Stations in queue. Alternatively, a double ring back will be heard at the AOR-CSE Station(s) in
queue.
As soon as the initial call has been completed, any calls that were waiting will be put through in
the order in which they were placed.
2.
Calling Into AOR-CSE Stations from the Command Unit
1. To call from a remote phone, dial the telephone number of the phone line connected to
the command unit
—you will hear one (1) beep when the system is ready. Go to
Step
(4)
.
2. To call from the Command Unit, simply pick up the handset
—you will hear one (1)
beep when the system is ready.
Press the button dedicated to the particular AOR-CSE Station. Go to
Step (5)
.
3. To call from a Sub-Command Unit, simply pick up the handset
—you will hear one (1)
beep when the system is ready. Go to
Step (4)
.
4. Enter the code to route to a specific AOR-CSE Station:
* 4 [1 through 5 or 1 through 0] *
5. There will be a short pause and then the AOR-CSE Station will answer with an open
channel (microphone and speaker are active.
