Area of Rescue Command Unit
Installation Guide
Model AOR-5 / Model AOR-10
Page
10
of
23
Rev. 4/13/2022
Copyright 2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
VII.
System Programming
List of Programming Codes for the Command Unit
Command
Function
* 31 * [up to 8 digits] *
Guard Access Code entry for phone programming
[Default * 31 * *]
* 30 * [up to 8 digits] *
Master Access Code entry to change Guard Access Code, Master
Access Code, and/or factory default the unit
[Default * 30 * 12345678 *]
* 30 * 14725836 *
Resets controller board programming to factory defaults.
Requires prior Master Access Code entry.
* 32 * [up to 8 digits] *
Programs and stores a new Master Access Code.
Requires prior Master Access Code entry.
* 33 * [up to 8 digits] *
Programs and stores a new Guard Access Code.
Requires prior Master Access Code entry.
* 34 * [1 to 99] *
Sets number of rings before controller board picks up when it is
dialed (1 to 99)
[Default 3]
* 37 *
Local Mode
NOTE:
All calls will route to the Command Unit handset and/or
Sub-Command Unit(s).
* 38 * [1 to 24] *
PSTN line test interval in hours (1-24 hours)
[Default 23]
* 39 * 1 *
PSTN line is a Central Office (CO) line from the telephone
company (allows 9 transfers)
[Default]
* 39 * 2 *
PSTN line is a PBX extension (disables 9 transfers)
* 56 * 1 *
Ignore any inbound PSTN line call when Stations, Command Unit,
and/or Sub-Command Unit(s) are active
[Default]
* 56 * 2 *
Allow any inbound PSTN line call to barge in when Stations,
Command Unit, and/or Sub-Command Unit(s) are active
* 57 *
Erase the “On Hold” voice message for calls in queue or on hold
* 58 *
Record the “On Hold” voice message for calls in queue or on hold.
Press the
#
key to stop recording or it will end after 50 seconds.
The recorded message will automatically play back.
* 59 *
Preview the recorded “On Hold” voice message for calls in queue
or on hold
* 62 *
Remote Mode
[Default]
