Area of Rescue Command Unit
Installation Guide
Model AOR-5 / Model AOR-10
Page
12
of
23
Rev. 4/13/2022
Copyright 2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Programming the Command Unit
1.
There are two (2) methods to program the Command Unit:
•
Via the keypad on a Sub-Command Unit;
•
Remotely by calling the phone number of the connected PSTN/POTS telephone line.
In either case, the Command Unit will answer and output one (1) beep.
2.
When entering programming codes, the controller board will provide the following feedback:
One (1) Beep
Programming code successfully accepted
Two (2) Beeps
Error code
—please re-enter the programming code
If you hear two (2) beeps or silence, re-enter the programming code again. If you continue to
hear two (2) beeps or silence a second time, hang up and try again.
3. Remote Mode:
1. Pick up a Sub-Command Unit handset (or remotely call into the connected PSTN/POTS
telephone line) and listen for one (1) beep.
2. Enter the Guard Access Code to enter programming mode:
*31**
3. Program the controller board for Remote Mode:
*62*
4. Program the controller board for the type of PSTN/POTS telephone line:
*39*1*
for a CO line from the telephone company (allows 9 transfers)
*39*2*
for a PBX extension (disables 9 transfers)
5.
Recording the “On Hold” Voice Message for Calls in Queue or on Hold:
a. Record the location message for the AOR-CSE Station in question:
*58*
Wait for the tone to begin speaking/recording. The recorded message has a maximum
length of
50 seconds
.
b. Press the
#
key to stop recording or it will end after 50 seconds. The recorded
message will automatically play back.
c. To review the recorded message again, press:
*59*
d. To delete the recorded message, press:
*57*
6. To exit programming and disconnect, hang up the call or press:
#
7. Move onto
Programming the AOR-CSE Stations
(p.14).
4. Local Mode:
1. Pick up a Sub-Command Unit handset and listen for one (1) beep.
2. Enter the Guard Access Code to enter programming mode:
*31**
3. Program the controller board for Local Mode:
*37 *
4. Recording
the “On Hold” Voice Message for Calls in Queue or on Hold:
a. To begin recording, enter:
*58*
