Area of Rescue Command Unit
Installation Guide
Model AOR-5 / Model AOR-10
Page
16
of
23
Rev. 4/13/2022
Copyright 2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
List of Programming Codes for the AOR-CSE Station
Command
Memory Slot
Function
0-20 digits
#00
Primary autodial phone number
*
0-20 digits
#01
Secondary autodial phone number
*
0-20 digits
#02
Third autodial phone number
*
0-20 digits
#03
Fourth autodial phone number
*
0-20 digits
#04
Fifth autodial phone number
*
6 digits
#18
Timing/dialing options. For further details, see
“Timing/Dialing
Options for the AOR-
CSE Station”
on p.17.
[Default 234721]
6 digits
#19
Change the security code
[Default 827827 or TAPTAP]
* 7
Add 4-second pause at any point of the dial string
[Enter No Digits]
#00 through #04
Clear autodial phone numbers
# 7
Exit programming mode and disconnect
# # #
Reset to factory defaults
*
For
Remote Mode with a CO Line connected
, the dial string should be set to the following format
to route the call through the
PSTN Line
port:
1 + Area Code + 7-digit Phone Number
Alternatively, any of the following numbers can be set as a phone number to reach local answering
points
:
5
calls the Command Unit handset
6
calls Sub-Command Unit #1
7
calls Sub-Command Unit #2
8
calls the Command Unit handset and the Sub-Command Unit(s)
—rings all at the same time,
first to pick up answers the call
NOTE:
After each AOR-CSE Station programming code, two (2) beeps indicate the code has been accepted.
Four (4) beeps indicate an error
—re-enter the code again.
